Once you are logged in you will find the configuration files right here. You need to register to download the GNS3 topology file. All loopback0 interfaces should be reachable. Ensure you have full reachability within AS 1.This turns them into hosts with a default gateway. Client1, Client2, FTP Server and Web Server are routers with IP routing disabled. It’s a good idea to draw your own network diagram. Advertise all loopback0 interfaces in BGP. Download the GNS3 file and the Cisco TSHOOT Exam Topology PDF and look at them thoroughly.Configure router Tilburg,Newyork and Hamburg with the correct IBGP neighbor peerings.Configure router Hamburg as the route-reflector for router Dusseldorf and Berlin.Configure router NewYork as the route-reflector for router LosAngeles and Boston.Configure router Tilburg as the route-reflector for router Amsterdam and Utrecht.Make sure switch Grasshopper does not use FastEthernet 1/1 to reach the root bridge in VLAN 10, you are not allowed to shutdown the interfaces. Change the hello timer on all switches for VLAN 10 to 4 seconds. You don’t see them in the topology picture or it would look like a picasso painting. You are not allowed to use the spanning-tree root command. All IP addresses have been preconfigured for you.

To fix this you configured the network with some route reflectors…this has saved you a lot of work but you want to take it one step further by clustering the network. The network has a lot of IBGP routers and you got sick of configuring all those neighbor peerings. Make changes on router Bilbo so traffic from 192.168.12.1 towards 33.33.33.33 is sent down the serial link. Make changes on router Bilbo so traffic from 1.1.1.0 towards router Meriadoc is sent down the serial link. Once you are logged in you will find the configuration files right here.As the senior network engineer for a large international company you are always trying to optimize your network and get the most out of your time. OSPF has been preconfigured for you for full connectivity.

Configure router Agent so it generates a trap when a new OSPF LSA is originated. GNS3Vault is offering you Cisco labs and scenarios that you can download and use with the GNS3 / Dynamips software.

Configure router Agent so it doesn’t send any traps or informs when something happens with the loopback0 interface.

Create a loopback0 interface on router Agent with IP address 1.1.1.1 /24.

Configure router Agent so it informs a device with IP address 192.168.12.3.

Configure router Agent to traps are sent to SNMPv2 server IP address 192.168.12.2.

This should only be used for read-only access.

Configure router Agent so it has a community string called “README”.Configure router Agent so only network 192.168.12.0 /24 is allowed to contact the router.Configure router Agent so the router can be reloaded through SNMP.Configure router Agent so the largest SNMP packet is 1500.Configure router Agent so the SNMP location is “Agency”.Configure router Agent so the SNMP contact is “007”.Configure router Agent so it uses community string “VAULT”.Optional: You can use the cloud interface to connect your router to a free syslog server like Kiwi Syslog Server (also works for SNMPv2).Some changes on the network have to be implemented through SNMPv2 and it’s up to you to configure your router as a SMPv2 agent. The Agency has created a new security policy and since you are part of the security team you need to help them implement them.

Gns3vault labs